Guidelines for Author/Authors:

• No part of the manuscript is copyrighted by any other publication nor is under review by any other formal publication, the Submitted manuscript is interpreted as a statement of certification for the same.

• Any author/authors shall obtain proper permission, if using any copyrighted materials in the manuscript/article, prior to the submission of the manuscript to IJATCA.

• Papers for the regular issues of the journal can be submitted, round the year, electronically at paper@ijatca.com, info@ijatca.com. After the final acceptance of the paper (based upon the detailed review process) the paper will immediately be published online. However, assignment of the paper to an specific Volume / Issue (see archive ) of the Journal will be taken up by the Editorial Board later; and the author will be informed accordingly.

• Submission of a paper implies that the work described has not been published earlier (except in the form of an abstract or academic thesis) and also not under consideration for publication elsewhere. The submission should be approved by all the authors of the paper. If a paper is finally accepted, the authorities, where the work had been carried out, shall be responsible for not publishing the work elsewhere in the same form. Research Paper, once submitted for contemptation in IJATCA, cannot be withdrawn unless the same is declined.

---

For the submission of Research Paper online, please refer to this link.

---

Instructions to Authors

Please read and implement the following instructions to ensure the review and publication of your paper is quick and efficient. Note: The Editors reserve the right to return manuscripts that are not prepared in accordance with the said instructions.

---

Manuscript Submission

Authors should submit Word (.doc) files or PDF (.pdf) files. Please contact on editor@ijatca.comfor additional help regarding manuscript submission.

Submission of a manuscript implies that the work narrated has not been published before; that it is not under consideration for publication anywhere else; that its publication has been approved by all the co-authors, if any, as well as by the responsible authorities – tacitly or explicitly – at the institute where the work has been carried out. The publisher will not be held legally responsible for any claims for compensation.

All contributions should be written in English with a brief abstract, a list of keywords and the author's mailing address. Authors are requested to put on the manuscript the mailing address to which the confirmation of acceptance and related documents should be sent.

---

Permissions

Authors who desire to include figures, tables, or text passages that have already been published elsewhere are required to acquire permission from the copyright owner(s) for both the print and online format and to share the evidence of permission seeked at the time of research paper submission. Any material received without such evidence will be assumed to procured from the authors.

---

Acceptance

Upon acceptance of an article(research paper), the author(s) is/are assumed to have transferred the copyright of the article to the publisher and required to submit Camera Ready copy of the research paper in accordance with IJATCA template (refer to link). The first author of published article will be provided with a free PDF of the published submission. These papers will appear on the journal's website and the readers can download them free of cost.

---

Online Research Paper Submission

Prospective authors are invited to submit full text papers including abstract, keywords, introduction, methodology, result description, tables, figures and references. Full text papers (.doc, .pdf) may be send via e-mail at paper@ijatca.com, info@ijatca.com Paper Template of it available at Click for Paper Template .

• Title Page:

  The title page should include the name(s) of the author(s), a concise and informative title, the affiliation(s) and address(es) of the author(s) and the e-mail address of the corresponding author.

• Abstract:

  Please provide an abstract of 150 to 450 words. The abstract should not contain any undefined abbreviations or unspecified references.

• Keywords: atleast four key words separated by commas.
• Introduction:

  When you submit your paper print it in two-column format, including figures and tables [1]. In addition, designate one author as the “corresponding author”. This is the author to whom proofs of the paper will be mailed. Proofs are sent to the corresponding author only [2].

• Theory/Calculation/Methodology: A Theory Section should extend, not repeat the information discussed in Introduction. In contrast, a Calculation Section represents a practical development from a theoretical basis.
• Result: Results should be clear and concise.
• Discussion: This section should explore the importance of the results of the work, not repeat them. Note: A combined Results and Discussion section is often appropriate.
• Conclusion and Future Scope: The main conclusions of the study may be presented in a short Conclusion Section. In this section, the author(s) should also briefly discuss the limitations of the research and Future Scope for improvement.
• Page Size and Layout: Set your page as A4, width 210, height 297 and margins as follows [3]:
  • Left Margin 17.8 mm (0.67")
  • Right Margin 14.3 mm (0.56")
  • Top Margin – 17.8 mm (0.7")
  • Bottom Margin – 17.8 mm (0.7")
  You should use Times Roman of size 10 for all fonts in the paper. Format the page as two columns:
  • Column Width 86.8 mm (3.42")
  • Column Height – 271.4 mm (10.69")
  • Space/Gap between Columns - 5.0 mm (0.2").
• Text Formatting:

  Title and authors: The title of the paper is centered 17.8 mm (0.67") below the top of the page in 24 point font. Right below the title (separated by single line spacing) are the names of the authors with the font size of 11pt. Author affiliations shall be in 9 pt. Body paragraphs: The main text for your paragraphs should be 11pt font. All body paragraphs (except the beginning of a section/sub-section) should have the first line indented about 3.6 mm (0.14"). Figures and Tables: Place illustrations (figures, tables, drawings, and photographs) throughout the paper at the places where they are first discussed in the text, rather than at the end of the paper. Number illustrations sequentially (but number tables separately). Place the illustration numbers and caption under the illustration in 10 pt font. Do not allow illustrations to extend into the margins or the gap between columns (except 2-column illustrations may cross the gap). If your figure has two parts, include the labels "(a)" and "(b)". Section headings: Section headings come in several varieties: first level headings: 1. Heading 1, second level: 1.2. Heading 2, third level: 1.2.3 Heading 3, forth level: (a) Heading 4, fifth level: (1) Heading 5

• References:

  Write Number citations successively in square brackets [1]. The sentence punctuation should follows the brackets [2]. Multiple references [2], [3] are each numbered with separate brackets [1]–[3]. Please note that the references at the end of this document are in the preferred referencing style. Please ensure that the provided references are complete with all the details and also cited inside the manuscript (example: page numbers, year of publication, publisher’s name etc.).

  Citation in text- Please ensure that every reference cited in the text is also present in the reference list (and vice versa). The references in the reference list should follow the standard IEEE reference style and citation of a reference. Web references- As a minimum, the full URL should be given and the date when the reference was last accessed. Any further information, if known (DOI, author names, dates, reference to a source publication, etc.), should also be included. Web references can be listed separately (e.g., after the reference list) under a different heading if desired, or can be included in the reference list, as well. Reference style: For Example:: A. Bonnaccorsi, "On the Relationship between Firm Size and Export Intensity," Journal of International Business Studies, XXIII (4), pp. 605-635, 1992. (journal style)

• Equations: If you are using Word, use either the Microsoft Equation Editor or the MathType add-on (http://www.mathtype.com) for equations in your paper (Insert | Object | Create New | Microsoft Equation or MathType Equation). “Float over text” should not be selected. Number equations consecutively with equation numbers in parentheses flush with the right margin, as in (1). First use the equation editor to create the equation. Then select the “Equation” markup style. Press the tab key and write the equation number in parentheses.
• Other recommendations Equalize the length of your columns on the last page. If you are using Word, proceed as follows: Insert/Break/Continuous.

---

Copyright

Upon receipt of accepted manuscripts from IJATCA, author(s) is/are assumed to transfer the copyright of the article to the publisher (refer to link).

---

Please note that submitting an article for publication means that you are the corresponding/submitting author and that IJATCA may retain your email address for the purpose of communicating with you about the article. You agree to notify IJATCA immediately if your details change.